• Security, Fire and Alarm Systems, CCTV and Electronic Security Wholesalers and Suppliers
Dantech, DADPC1206, 12V DC (13.7V) 6A DIN Rail Power Supply

Dantech, DADPC1206, 12V DC (13.7V) 6A DIN Rail Power Supply

  • Brand:Dantech
  • Product Code:DADPC1206
  • Availability:Please Call or Email Us to Check Availability

Please contact sales on 01628 669124 or email sales@hunters-wholesalers.co.uk for a quote on this product 


Dantech, DADPC1206, 12V DC (13.7V) 6A DIN Rail Power Supply

This DIN rail mounting power supply unit features SPCO relay monitoring contacts, output controls and battery support. This unit will seamlessly switch from mains power input to battery powered input in the event of a mains power failure, if this occurs, the unit will also change over SPCO relay contacts for switching or signalling other equipment that the mains power has failed to this power supply. When mains power is restored, the unit will change over the monitoring relay contacts and automatically re-charge the connected VRLA battery.

During prolonged mains power failure, if the connected VRLA battery is nearing depletion, the 'Low volt' SPCO relay contact will change over to switch or signal other equipment that the battery power is nearly depleted.

Deep discharge protection: VRLA batteries can be damaged from complete discharge and reduce the life span and capacity of the battery. This power supply features deep discharge protection, and will automatically disconnect the battery before deep discharge occurs and automatically re-connects the battery for charging when mains power is available.

Output one (O/P1) provides a continuous power output regardless of the output control status. Output two (O/P2) can be switched on or off by the output control terminals. The output control 'enable' terminals will enable the output when closed circuit and disable (turn off) the output when open circuit.

Restart function: A PCB link jumper controls if this function is enabled or disabled. When the jumper is fitted, the restart function is disabled. When the link jumper is removed the restart function is enabled, and O/P2 will not reenable when switched output enable has been open circuit and then closed circuit, until 'restart' contacts have a momentary closed circuit to confirm re-enable of the output.

Battery start: Each module has a 'Battery start' button, this will enable the outputs from battery power without mains power connected.

Key Features:

  • Use with or without stand-by batteries
  • With constant and remote control outputs

Output control

  • Switched and non-switched outputs
  • Control output with remote enable switching
  • Use with or without restart function for enabled output

Battery back-up support

  • Seamless switching from mains to battery power during failures
  • Low battery SPCO Relay contacts for signalling and/or switching equipment
  • Battery deep discharge protection
  • Automatic battery charging
  • Use 12V battery for 12V output versions
  • Use 24V battery (2 x 12V in series) for 24V output versions
  • Only connect new batteries in a good state of charge

Specifications:

  • Power consumption: < 100VA
  • Output: 2 x 12V DC (13.7V)
  • Max current: 6A

For more details, please refer with our attached datasheet.

Contact us on sales@hunters-wholesalers.co.uk for more specific product information and pricing installation and training.

There are no reviews for this product.

Write a review

Please login or register to review