Elmdene, GEN2-08-B, 12V DC 1.0 Amp Grade 2 PSU Box (Type B - Clam Lid)

Elmdene, GEN2-08-B, 12V DC 1.0 Amp Grade 2 PSU Box (Type B - Clam Lid)

12V d.c. Switch Mode PSU(13.8V) 1.0A to load + additional current for battery charging. Grade 2 Intruder systems, will accommodate Communication Devices. Mains, Battery and PSU volt free fault outputs. Deep discharge protection. Diagnostic LEDs. Lid tamper. Low quiescent battery standby current. Fit up to 7/8Ah battery. 330H x 355W x 80D - clam lid

The GEN Switch Mode range of power supplies has been specifically designed to provide a comprehensive and flexible range for engineers designing Intruder Alarm Systems to grade 2 and 3 under PD6662:2010 / EN50131-6:2008, with built in quality and reliability.

Features:

• High Efficiency Switch Mode Operation
• Comprehensive Battery Management
  • Deep Discharge Protection
  • Battery Fault Detection (Grade 3)
  • High Efficiency 3 Stage Charging (18Ah)
• Dedicated Fault Outputs
  • EPS Fault (mains fail)
  • APS Fault (battery fault) (Grade 3)
  • PSU Fault (general fault)
• Internal LED PSU Status
• High Security Front and Rear Tamper (Grade 2 front only)
• Full Rated Current To Load + Battery Charging
• Electronic Overload Protection
• Mains Transient Protection

Specification:

• Output (mains on): 13.8V dc nominal
• Load Output: 08 Maximum 1.0A 12 hours - 580/660mA (7/8Ah)
• Mains Supply: 90V  - 265V a.c @50/60Hz
• Environment: -10C to 40C @ 95%RH
• Enclosure Type A: 330H x 355W x 80D - clam lid*
• Box Sizes for battery: '08' models1 x 7 or 8Ah 1.0A**
• Standards: EN2 - Grade 2

*Communication devices will fit into a 'B' size box when used with a 7/8Ah battery.

 **Full current to load plus additional current to charge standby battery.

GEN range Complies with the following standards::

EN50131-6:2008      GEN2 –Grade 2        GEN3 – Grade 3           All Environmental Class II

For more details, please refer with our attached datasheet.