Scope, DL3-10-12V, 10-Zone Programmable DigiLink 3 Transmitter - 12V

Scope, DL3-10-12V, 10-Zone Programmable DigiLink 3 Transmitter - 12V

System Overview:

The Scope Digilink MK2 DL1012V and DL512V are 12V dc* powered, programmable Short Range Device (SRD) radio systems which can be used to transmit data to fixed base stations and/or portable receivers.

The unit is supplied with either 5 or 10 inputs, which can be hardware configured to accept either dry contact (no voltage) or voltage (5-18V dc) triggers. Each input is pre-programmed as either N/O (Normally Open), N/C (Normally Closed) or C/S (Change of State). Triggering any of the inputs (zones) will result in pre-programmed data (including up to 80 characters of text message) being transmitted to the selected receiver or group of receivers.

The unit can be programmed to repeat transmit (1-5 repeat transmissions or until reset) if required. In addition, the trigger filter time can be defined between 100 milliseconds and 25 seconds (period for which the zone must remain in the active state before triggering). One input (IN9) can be configured as a Reset to clear any current transmission cycles. This can also be used as an “Arm/Disarm” facility for the alarm inputs. Various other parameters can be programmed to suit specific user requirements.

*24V dc input units also available, model codes DL1024V and DL524V.

System Specification:

• Input Voltag: 12 to 13.8V dc
• System Power Consumption: less than 300uA (micro Amp) standby, 300mA transmit.

Transmitter:

• Power output: 500mW max
• Frequency Range: 450-470 MHz
• Channel Spacing: 12.5KHz
• Adjacent Channel: better than 200nW @ 4.5 KHz deviation
• TX Baud Rate: 512 or 1200
• Radio Standards: ETS EN 300 220
• Notified Body No. 0891
• EMC Standards: ETS EN 301 489

General:

• Ports: 10 dry contact/voltage inputs (configurable), Open Collector (siren) output: 1A max, Relay output for, Power Fail indication, USB port for programming function only
• Footprint (mm): 184 (L) x 138 (W) x 45 (D) max

For more details, please refer with our attached manual.