EMS FC-K555, Network Interface Card for Wired and Wireless Networks

EMS FC-K555, Network Interface Card for Wired and Wireless Networks (One required per control panel)

Hardwired Network Card for 1 or 2 Loop Control Panel

Key Features:

* Up to 64 nodes
* High integrity protocol
* Fully secure against short or open circuit faults
* Simple 2-wire loop connection
* Supports open ended networks for retrofit applications
* Repeaters share network connection
* Network wide test and disablement functions
* Network wide cause and effect logic
* Flexible configuration options
* Panels configurable to act on network events or not as required
* Apollo & Hochiki panels supported on single network

Product Overview:

The flexibility of the Syncro system can be further enhanced by connecting control panels and repeaters together using a high integrity network.

A simple 2-wire connection between each panel allows events to be transmitted to other parts of the system to provide indication or control on a system wide basis.

Using the Loop Explorer configuration programme, up to 64 nodes can be programmed to respond in a variety of ways to any system events as required.

This flexibility extends the comprehensive cause and effect programming capability of Syncro control panels to the entire network allowing actions, test modes or disablements to be started from any point.

The fault tolerance of the network is such that any single open or short circuit fault will not result in any loss of information. Multiple faults are isolated and the network breaks into smaller networks which continue to work autonomously.

Technical:

Product code: K555
Protocol: RS485
Connection: Two wire loop
Current Consumption: 40mA
Integrity: Full isolation of faulty nodes or wiring segments
Indicators: Data In and Data Out communications status
Cable length: 1200 metres to adjacent nodes (subject to cable type)
Cable type: Belden 9271, Belden 9860, FP200 Gold
Compatible panels: Syncro/Syncro AS (required for networking) Syncro Response/Syncro 6 & 8 loop, Syncro Focus (supplied with panel)

Hardwired Network Card for 1 or 2 Loop Control Panel

Features

* Up to 64 nodes
* High integrity protocol
* Fully secure against short or open circuit faults
* Simple 2-wire loop connection
* Supports open ended networks for retrofit applications
* Repeaters share network connection
* Network wide test and disablement functions
* Network wide cause and effect logic
* Flexible configuration options
* Panels configurable to act on network events or not as required
* Apollo & Hochiki panels supported on single network

Product Overview

The flexibility of the Syncro system can be further enhanced by connecting control panels and repeaters together using a high integrity network.

A simple 2-wire connection between each panel allows events to be transmitted to other parts of the system to provide indication or control on a system wide basis.

Using the Loop Explorer configuration programme, up to 64 nodes can be programmed to respond in a variety of ways to any system events as required.

This flexibility extends the comprehensive cause and effect programming capability of Syncro control panels to the entire network allowing actions, test modes or disablements to be started from any point.

The fault tolerance of the network is such that any single open or short circuit fault will not result in any loss of information. Multiple faults are isolated and the network breaks into smaller networks which continue to work autonomously.

Technical

Product code: K555
Protocol: RS485
Connection: Two wire loop
Current Consumption: 40mA
Integrity: Full isolation of faulty nodes or wiring segments
Indicators: Data In and Data Out communications status
Cable length: 1200 metres to adjacent nodes (subject to cable type)
Cable type: Belden 9271, Belden 9860, FP200 Gold
Compatible panels: Syncro/Syncro AS (required for networking) Syncro Response/Syncro 6 & 8 loop, Syncro Focus (supplied with panel)